User Manual Neff Z11TC10X0 Clip rail Stainless steel

You will have no more trouble installing the Neff Z11TC10X0 Stainless steel Clip rail. Here we share a pdf user manual.

Detaching and refitting the rails

A Risk of burns!

The rails become very hot. Never touch the hot rails. Always allow the appliance to cool down. Keep children away from the appliance.

Detaching the rails

1. Raise the front of the rail a little and detach it.
2. Then pull the whole rail to the front and remove it.

Hooking the rails

The rails only fit on the right or the left side. The pull-out rails must pull out towards the front.

1. First, insert the rail in the center of the rear socket a until the rail lies against the wall of the cooking compartment, and push it towards the back
2. Then insert it into the front socket C until the rail also lies against the wall of the cooking compartment here, and push it downwards.

Note: Depending on the pull-out system, you must change the basic settings on your appliance. To do this, refer to the “Basic settings” section in the instructions for use.

Unhooking and hooking in telescopic shelves

A Risk of burns!

The telescopic shelves become hot when the appliance is in use. Take special care not to get burnt when they are pulled out.

Removing the bar

Telescopic shelves are removed and fitted like bars.

1. Push the bar towards the rear a until it can be pulled outwards
2. Unhook the bar at the rear and remove it.

Hooking in the telescopic shelf

1. Hook in the telescopic shelf at the rear.
2. Slide the telescopic shelf to the rear a and downwards b at the pin c.
3. Ensure that the hook is hooked onto the pin c.

Note: Depending on the pull-out system, you must change the basic settings on your appliance. To do this, refer to the “Basic settings” section in the instructions for use.